Error code · Range

Electrolux Induction Range Codes 32, 33, 72 and 73: Power Supply Defect

High · stop use, call now

Code: 32 / 33 / 72 / 73
Appliance: Range
Brand: Electrolux
Warranty: 30-day workmanship

What 32 / 33 / 72 / 73 means

On the Electrolux Wave-Touch induction built-in slide-in ranges, such as the EW30IS65JS and EW30IS6CJS, codes 32 and 33 report a power supply defect in the left cooking zones, and codes 72 and 73 report the same problem on the right. The control found that the supply section feeding that side is not behaving correctly, so it shuts that side down for protection. The code shows on the cooktop display, and the zones on the affected side stay cold.

Common causes of 32 / 33 / 72 / 73

Power supply section in the induction housing
Connectors and wiring to that side
Cooktop control board

✓ One safe check you can try

1. Shut off the range at its breaker, wait half a minute, then restore power. 2. Make sure the breaker is switched fully on and is not hot to the touch. 3. Note which side shows the code, and whether the other side still heats. 4. If the code comes back, leave that side off and call us.

! Why to stop there

This code names the supply section on one side, though it cannot say whether a board, a connector or the house supply is responsible, so we check the incoming power first.
We test the affected side against the working side.
We put the price in writing ahead of the work, and if the range is past the point of making repair sensible, we tell you directly.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

SAb / SbWhat SAb and Sb Mean on an Electrolux Range SFSF After a Power Outage in Sabbath Mode on an Electrolux Range F92F92 on an Electrolux Range: Door Lock Circuit Reading F93F93 Door Lock Trouble on an Electrolux Range F94Electrolux Range Error F94 - Door Lock Not Responding HEWhy Your Electrolux Induction Cooktop Says HE HE (radiant)HE Hot Element Message on an Electrolux Radiant Cooktop HotHot on the Display of an Electrolux Range After Self-Clean

32 / 33 / 72 / 7332 / 33 / 72 / 73 questions

Why are there four codes?

The codes are split by side and by type. Codes 32 and 33 are for the left cooking zones, and codes 72 and 73 are for the right cooking zones.

Does this mean my house wiring is bad?

Not necessarily. We check the incoming voltage at the range first, because a problem in the house supply can look the same as a problem inside the range.

Should I repair or replace an older induction range?

That depends on which part is needed. With the written price in hand, you can weigh it against a new range, and we give our own opinion if you ask.

Book a visit

Still seeing 32 / 33 / 72 / 73?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150