Error code · Dishwasher

Electrolux Dishwasher Codes i52 and i53: Wash Pump High Current

Medium · inspection needed

Code: i52 / i53
Appliance: Dishwasher
Brand: Electrolux
Warranty: 30-day workmanship

What i52 / i53 means

These two codes appear on Electrolux ICON built-in dishwashers such as the EI24ID50QS and EW24ID80QS. Both say the wash pump motor is drawing too much current. An i52 comes from the hardware current limit, which is roughly 1.3 amps, while an i53 is the software limit, set a little lower at about 1.0 amp. The wash cycle stops, and you may hear the pump strain or hum first.

Common causes of i52 / i53

Wash pump that is binding or overloaded
Motor winding or its connector
Debris inside the pump housing
Motor control board output

✓ One safe check you can try

1. Press Cancel and open the door. 2. Pull out the lower rack and clean the filter by hand, checking for broken glass or a bone. 3. Spin the lower spray arm to confirm it is not stuck. 4. Close the door and run a short cycle. If i52 or i53 returns, stop and call us.

! Why to stop there

High current can come from a jam, a worn motor or a board output, and the display cannot separate them, so we test each.
We inspect the pump for debris that the filter did not catch.
We quote the repair first, and you decide before work begins.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

PRESS STARTElectrolux Dishwasher Message PRESS START: Close the Door iF0Electrolux Dishwasher Code iF0: Overfilling iF1Electrolux Dishwasher Code iF1: Water Level Too High L4 / L5 flash pattern (no-display models)Electrolux Dishwasher L4 and L5 Light Flashes: Reading the Code LOCElectrolux Dishwasher Message LOC: Controls Locked PFElectrolux Dishwasher Message PF: Power Was Interrupted i60Electrolux Dishwasher Code i60: Water Not Heating Up i61Electrolux Dishwasher Code i61: Water Too Hot

i52 / i53i52 / i53 questions

What is the difference between i52 and i53?

Both mean high current at the wash pump. i52 is tripped by the hardware limit and i53 by the software limit, which is a bit lower, so i53 can show up first.

Could a dirty filter cause this?

A clogged filter alone rarely does, but debris that reaches the pump can drag on it. Cleaning the filter is a safe first step.

Is this expensive to fix?

It depends on whether the pump is jammed or the motor is worn. We tell you which it is and give you a written price before we start.

Book a visit

Still seeing i52 / i53?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150