Booking today · Houston arrival windows 9–12 · 1–4 · 4–7 Independent Electrolux specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 979-9150 Request a Service Visit
Error code · Dishwasher

Electrolux Dishwasher Codes iC1 and iC2: Internal Communication

Electrolux ICON dishwashers such as the EI24ID50QS and EW24ID80QS use these two codes for problems on the internal data lines between boards. An iC1 reports an error on the MACS bus, and an iC2 reports an…

High · stop use, call now
Request a Service Visit(713) 979-9150
Code
iC1 / iC2
Appliance
Dishwasher
Brand
Electrolux
Warranty
30-day workmanship

What iC1 / iC2 means

Electrolux ICON dishwashers such as the EI24ID50QS and EW24ID80QS use these two codes for problems on the internal data lines between boards. An iC1 reports an error on the MACS bus, and an iC2 reports an error on the ADSI link. Both mean parts of the control system are not exchanging information reliably. The dishwasher may stop, ignore buttons or start a cycle and then quit.

Common causes of iC1 / iC2

  • Wiring harness between the boards
  • Display board
  • Main control board
  • Loose or corroded connector
✓ One safe check you can try

1. Press Cancel and watch the display. 2. Close the door firmly and try one short cycle. 3. Write down whether the code was iC1 or iC2 and when it appeared. 4. If it comes back, leave the dishwasher off and call us.

! Why to stop there
  • A communication error can come from a wire, a connector or a board, and we trace each link before changing anything.
  • We check the harness for heat or moisture damage.
  • The price is written and approved first, and you get a 30-day warranty.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Dishwasher codes

PRESS STARTElectrolux Dishwasher Message PRESS START: Close the Door i60Electrolux Dishwasher Code i60: Water Not Heating Up i61Electrolux Dishwasher Code i61: Water Too Hot i70Electrolux Dishwasher Code i70: Temperature Sensor Out of Range i80 / i81Electrolux Dishwasher Codes i80 and i81: Automatic Door Opener i90Electrolux Dishwasher Code i90: Control Memory or Display Data Error iB0Electrolux Dishwasher Code iB0: Sensor Calibration Not Finished iC0Electrolux Dishwasher Code iC0: Display Not Communicating
iC1 / iC2iC1 / iC2 questions
What do MACS and ADSI mean?

They are names for the internal data links the boards use. You do not need to know more than that: the message says two boards are not talking.

Can moisture cause this?

It can, if damp air reaches a connector. We look for corrosion on the plugs.

Why does the dishwasher quit mid-cycle?

If the link drops, the control loses instructions and stops to stay safe.

Book a visit

Still seeing iC1 / iC2?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150
☎ Call our office ▤ Request a Service Visit