Error code · Dishwasher

Electrolux Dishwasher Code i58: Wash Pump Connection Open

Medium · inspection needed

Code: i58
Appliance: Dishwasher
Brand: Electrolux
Warranty: 30-day workmanship

What i58 means

On Electrolux ICON built-in dishwashers like the EI24ID50QS and EW24ID80QS, i58 reports a problem with the wash pump motor connection. The control believes the motor plug is not connected, a phase is detached, or a winding inside the motor is broken. The motor then cannot run, so the dishwasher stops and the dishes are left unwashed, usually with water still in the tub.

Common causes of i58

Wash pump plug or its contacts
Broken winding inside the wash motor
Wiring between the motor and the control
Motor control board output

✓ One safe check you can try

1. Cancel the cycle, wait for the dishwasher to stop, then open the door. 2. Check the tub for standing water and scoop out what you can with a cup. 3. Clean the filter by hand. 4. Close the door and try a short cycle once. If i58 appears again, do not repeat it and call us.

! Why to stop there

An open connection can be a loose plug, a broken wire or a burned winding, so we test the circuit end to end.
We confirm the control is sending the right signal before we blame the motor.
The price is agreed in writing before the work, and you get a 30-day warranty on it.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

PRESS STARTElectrolux Dishwasher Message PRESS START: Close the Door LOCElectrolux Dishwasher Message LOC: Controls Locked PFElectrolux Dishwasher Message PF: Power Was Interrupted i60Electrolux Dishwasher Code i60: Water Not Heating Up i61Electrolux Dishwasher Code i61: Water Too Hot i70Electrolux Dishwasher Code i70: Temperature Sensor Out of Range i80 / i81Electrolux Dishwasher Codes i80 and i81: Automatic Door Opener i90Electrolux Dishwasher Code i90: Control Memory or Display Data Error

i58i58 questions

Does i58 mean the motor is burned out?

Not necessarily. The code says the circuit is open. That can be a plug that worked loose, which is a smaller repair than a new motor.

Why is there water left in the tub?

The dishwasher stopped partway through the cycle. Water that was already in the tub stays until the drain pump runs again.

Can I plug the motor back in myself?

No. The motor sits behind panels, and the dishwasher has to be disconnected from power for that work. We handle it.

Book a visit

Still seeing i58?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150