Booking today · Houston arrival windows 9–12 · 1–4 · 4–7 Independent Electrolux specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 979-9150 Request a Service Visit
Model library · Electrolux Range

ECFG3068AS

Electrolux ECFG3068AS Gas Range Repair

Most common issues on this model

  1. Oven igniter that glows but will not open the gas valve
  2. Burner flames that run too high after an LP conversion
  3. Control lock that was left on, so the knobs or oven seem dead
  4. Oven that is slow to reach temperature

The ECFG3068AS is the all-gas version of Electrolux’s current 30-inch front-control freestanding range, finished in stainless steel and with a gas convection oven. The build on the plate reads ECFG3068ASA. It is a current model, and it is often the right size for a standard Houston kitchen cutout.

With a control lock on the front, some calls turn out to be a lock left on after cleaning, so we check that first. After that, a gas oven that does not light points to a weak igniter or a valve problem, and flames that run too high on LP point to a conversion that was not completed. We check the fuel setup before adjusting any burner.

Model and build come off the label, then the right part gets ordered. You get an itemized quote before the work, and a 30-day warranty follows it. We would rather say a simple fix is enough than sell you a part you do not need.

Key features

  • Gas range for 30-inch cutouts, freestanding, front controls
  • Stainless steel exterior
  • Convection gas oven
  • Build ECFG3068ASA
ECFG3068ASECFG3068AS questions
My controls do not respond on my ECFG3068AS. Is it broken?

It may be the control lock. We check that first, since it can look like a dead panel. If the lock is off, we test the control board and the connections before quoting a part.

Why are my burner flames too tall after converting to LP?

The burners may not have the right orifices or the regulator may be set for natural gas. We check how the range is set up and adjust it properly. The price is quoted first.

Will the oven light if the igniter glows?

Not always. A weak igniter can glow without opening the gas valve. We measure it with a meter and replace it if it is below the required current.

Book a visit

Book repair for your ECFG3068AS

Book online in about a minute, or give us a call. Same-day appointments are available inside the Loop on most days, and next-day service across the rest of Houston.

☎ Call our office ▤ Request a Service Visit