Electrolux Dishwasher Code i5F: Drain Pump Plug Connection
The i5F code on Electrolux ICON dishwashers, including the EI24ID50QS and EW24ID80QS, concerns the plug connection of the drain pump. The control checks the pump circuit and finds it open, as if the plug is not…
- Code
- i5F
- Appliance
- Dishwasher
- Brand
- Electrolux
- Warranty
- 30-day workmanship
What i5F means
The i5F code on Electrolux ICON dishwashers, including the EI24ID50QS and EW24ID80QS, concerns the plug connection of the drain pump. The control checks the pump circuit and finds it open, as if the plug is not seated properly. Without a connected pump the dishwasher cannot drain, so you will see a cycle that stops and water left in the tub.
Common causes of i5F
- Drain pump plug or terminal contacts
- Wiring between the pump and the control
- Drain pump winding
- Motor control board output
1. Hit Cancel, then open the door slowly in case of hot steam. 2. Bail out standing water with a cup. 3. Clean the filter by hand. 4. Close the door and run a short rinse once. If i5F shows again, stop and call us.
- An open circuit can be a loose plug, a damaged wire or a bad pump, so we test each section.
- We look for signs of moisture or corrosion at the connector.
- We give you a price in writing, and nothing starts until you agree.
Other Dishwasher codes
Is i5F the same as i5E?
No. i5E says the pump is locked. i5F says the pump circuit looks disconnected, so the cause is in the plug or wiring rather than a jam.
Can vibration loosen the plug?
It is possible over many years of cycles. A plug that seats poorly is an easier repair than a failed pump.
Can I check the plug myself?
No. It is behind panels, and the dishwasher has to be disconnected from power first. We do that work.
Still seeing i5F?
A technician diagnoses it on site and gives you the price in writing before any work starts.