Error code · Dishwasher

Electrolux Dishwasher Codes iD0 and iD1: Motor Speed Signal Missing

Medium · inspection needed

Code: iD0 / iD1
Appliance: Dishwasher
Brand: Electrolux
Warranty: 30-day workmanship

What iD0 / iD1 means

In the service mode of Electrolux ICON dishwashers such as the EI24ID50QS and EW24ID80QS, iD0 and iD1 point to a missing tacho signal from the wash motor. The tacho tells the control how fast the motor is spinning. An iD1 is critical and means no signal for five seconds. An iD0 means no signal for 30 seconds, and the motor then runs at full speed with no heating. You may notice only a loud, hot-less wash.

Common causes of iD0 / iD1

Tacho feedback from the wash motor
Wash motor wiring or connector
Motor control board input
Wash motor winding

✓ One safe check you can try

1. Cancel the cycle, wait for the dishwasher to stop, then open the door. 2. Clean the filter and check the lower spray arm turns freely. 3. Latch the door and try one short wash. 4. If the wash sounds unusually loud or the dishes come out cold and dirty, call us.

! Why to stop there

These codes show in service mode only, so we need to read them there to confirm what the control saw.
We check the motor feedback and the wiring.
We quote the repair in writing, and you approve it before work.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

PRESS STARTElectrolux Dishwasher Message PRESS START: Close the Door LOCElectrolux Dishwasher Message LOC: Controls Locked PFElectrolux Dishwasher Message PF: Power Was Interrupted i60Electrolux Dishwasher Code i60: Water Not Heating Up i61Electrolux Dishwasher Code i61: Water Too Hot i70Electrolux Dishwasher Code i70: Temperature Sensor Out of Range i80 / i81Electrolux Dishwasher Codes i80 and i81: Automatic Door Opener i90Electrolux Dishwasher Code i90: Control Memory or Display Data Error

iD0 / iD1iD0 / iD1 questions

Why can I not see the code?

These codes appear in service mode, not on the everyday display. What you notice is the dishwasher behavior.

Why does the wash sound loud?

With no speed feedback the motor runs at full speed. That is also why there is no heating.

Is it safe to run?

We suggest you wait for service. Running a pump with no speed control wastes energy and can wear it faster.

Book a visit

Still seeing iD0 / iD1?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150