Error code · Dryer

Electrolux Dryer Codes H4 and B4: Incorrect Wiring

High · stop use, call now

Code: H4 / B4
Appliance: Dryer
Brand: Electrolux
Warranty: 30-day workmanship

What H4 / B4 means

On newer Electrolux dryers with the two-character display, H4 and B4 mean incorrect wiring. The brand calls it a known installation issue and tells the owner to contact the installer, so the dryer is telling you its power connections are not set up the way it expects. This often shows after a new install, a move, or a cord change. The dryer will not run its cycle until the wiring is corrected.

Common causes of H4 / B4

Power cord and terminal block connections
Outlet type and wiring behind it
Control board reading the supply

✓ One safe check you can try

1. Stop the dryer and disconnect its plug. 2. Think about whether the dryer is new, was moved or had its cord changed. 3. Contact the installer who set it up, as the guidance recommends. 4. Do not open the back panel or change any wiring yourself.

! Why to stop there

The code points to the wiring but does not say where, so we check the outlet and cord before the dryer itself.
When the installer cannot be reached, we can check the connections and tell you what is wrong.
You see a written price first, and the repair carries a 30-day warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

EF1Electrolux Dryer Code EF1: Ventilation Blockage EF3Electrolux Wave-Touch Dryer Code EF3: Max Timeout Timer EF8Electrolux Dryer Code EF8: Key Stuck H2 / B2Electrolux Dryer Codes H2 and B2: Power Supply Issue E71 / E72Electrolux Dryer Codes E71 and E72: Outlet Temperature Sensor E73 / E74Electrolux Dryer Codes E73 and E74: Inlet Temperature Sensor E91Electrolux Dryer Code E91: Communication Error E92 / E93Electrolux Dryer Codes E92 and E93: Board Mismatch or Data Error

H4 / B4H4 / B4 questions

Why does a new dryer show H4 or B4?

The most common reason is the cord or terminal connections do not match the outlet. That is an installation matter, which is why the guidance sends you to your installer.

Can I use the dryer anyway?

No. Wrong connections can damage the dryer and are a safety concern, so keep it unplugged until the wiring has been checked by us or by a licensed electrician.

Can you fix it if my installer will not come back?

Yes, we can look at the cord and the connections, then explain what needs to change before you approve anything. If the house wiring itself needs an electrician, we say so plainly.

Book a visit

Still seeing H4 / B4?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150