A drum that spins with no heat at all is not the same issue as slow drying. With an Electrolux front-load dryer, a few simple checks come before any part replacement.
Check the basics
- Look at the circuit breaker. An electric dryer uses a double breaker; if one half trips, the drum can turn without heat.
- Confirm the load size and cycle. Air-only cycles, such as fluff, use no heat.
- Clean the lint filter.
- Check the vent for blockage or a crushed hose behind the dryer.
- Feel the exhaust outside the house while the dryer runs. Strong, warm air is a good sign; weak or cold air is not.
Electric or gas
Electric dryers rely on a heating element, a thermal fuse and a thermostat. Gas dryers depend on an igniter, gas valve coils and a safety sensor. The same cold drum can come from any of these.
What we check
- Power at the terminal block and the breaker.
- The thermal fuse, which often blows when airflow is restricted.
- The heating element or igniter.
- Thermostats and sensors.
- The vent run and the restriction that caused any blown part.
Why replacing the fuse alone is not enough
A thermal fuse blows to prevent overheating. If the vent is blocked, a new fuse will blow again. We clear the cause and fix the part together.
Gas safety
A gas smell near a gas dryer means you should get everyone outside and phone the gas utility from there. Gas connector or valve work at the wall belongs to a plumber, and we will say so.
Older dryers
Dryers past the 10-year mark often need a new heating part. They are typically worth repairing when the drum and motor are in good shape. We tell you when they are not.
Heating repairs are described on the dryer repair page. Phone us or use the contact form and tell us whether the dryer runs on gas or electricity and roughly how old it is. We look at the vent run during the visit, and you decide on the repair after reading our written estimate. See where we work on the service area map.