Error code · Washer

Electrolux Washer E35 Overfill Error

High · stop use, call now

Code: E35
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E35 means

An overfill is what E35 reports on an Electrolux Wave-Touch or IQ-Touch front-load washer such as the EWFLW65HIW, EIFLW55HIW, EFLS627UTT or ELFW7637AT. The pressure sensor reads more water than the washer should hold, or water that keeps coming in. Extra water can spill onto the floor. Older washers like these are still common in Houston, and we repair them and tell you honestly if a repair is not worth it. After a recent installation or move, check the setup first.

Common causes of E35

An inlet valve that keeps letting water in
A clogged or leaking air trap
The pressure sensor
The main control board

✓ One safe check you can try

1. Close both water faucets to the washer. 2. Press Cancel to clear the code. Press Start only if the tub is not taking in more water. 3. Unplug the washer for a minute, then plug it back in. 4. After a new installation or a move, ask the installer to recheck the setup. If E35 comes back, call us.

! Why to stop there

A valve, an air trap and a sensor can all cause an overfill, so we test them one by one.
We make sure no standing water remains in the washer.
You hear the price before any part is ordered, and our workmanship is warranted for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" E93 / E97Electrolux Washer E93 / E97: Console or Main Board Control Problem E94Electrolux Washer Code E94: Main Board Control Problem E95Electrolux Washer E95: Memory Chip Communication E98 / E9FElectrolux Washer Codes E98 and E9F: Console Control and Communication EA1Electrolux Washer Code EA1: Power Frequency Outside Its Limits EA2 / EA3Electrolux Washer EA2 and EA3: Supply Voltage Too High or Too Low

E35E35 questions

Is E35 a danger to my floor?

It can be, since extra water may spill. Close both faucets, unplug the washer and do not leave it running while you are out of the house.

Why would a washer keep taking in water?

The inlet valve may be stuck open, the air trap may be clogged, or the pressure sensor may be misreading. We test each one to find the cause.

Is it fine to run another load after Cancel?

Cancel clears the code, but if E35 returns the cause is still there. Keep the washer off and call us rather than risk an overflow.

Book a visit

Still seeing E35?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150