EW24ID80QS
Electrolux Wave-Touch EW24ID80QS Dishwasher Repair
Most common issues on this model
- Controls that do not respond or beep without starting
- Water left in the tub after a cycle
- Poor cleaning on the lower rack
- Seal that weeps at the bottom corner
The EW24ID80QS belongs to the EW24ID80 series: a 24-inch built-in dishwasher with Wave-Touch controls. Electrolux has discontinued it, so most units are older ones. We repair them, and we say plainly when a repair is not a good use of your money.
We start with the quick checks. The door has to close and register, the filter has to be clean, and the drain path has to be open. If those are fine, we test the panel, then the pump and the inlet valve. A seal that weeps at the corner is something we can usually see while the unit runs.
The QS number is noted from the label before ordering. We tell you the cost in advance, and we give you a 30-day warranty on completed repairs.
Key features
- Built-in dishwasher, 24 inches, EW24ID80 series
- Wave-Touch controls
- Finish code QS
- Discontinued model
Error codes this model can show
Why does my dishwasher beep and not start?
On the EW24ID80QS the door switch, a water supply problem or the control board can keep a cycle from beginning. We test the door first and move through the others in order.
Why does my lower rack come out dirty?
Food in the filter, a clogged spray arm or poor fill are the usual causes. We clean and test those first because they are less costly than pump work.
Is this EW24ID80 model still worth fixing?
Often yes. If the tub and racks are sound, a repair to the drain, a seal or the controls costs far less than replacement. We tell you the numbers.
Book repair for your EW24ID80QS
Book online in about a minute, or give us a call. Same-day appointments are available inside the Loop on most days, and next-day service across the rest of Houston.