Error code · Washer

Electrolux Washer Code E67: Heater Relay Sensing

Medium · inspection needed

Code: E67
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E67 means

E67 shows on heater-equipped front-load Electrolux washers from the Wave-Touch and IQ-Touch family, such as the EWFLW65HIW and EIFLW55HIW, when the control detects a problem with the heater sensing relay. In plain terms, the control cannot confirm that the internal water heater is switching correctly. Washers with no internal heater do not show it. The display reads E67 and the cycle may stop. It is an older design that we still repair, and we tell you honestly when the repair would not pay off.

Common causes of E67

The heating element
The wiring to the heater
The heater relay on the main control board

✓ One safe check you can try

1. Switch the washer off. 2. Try a cold or warm wash to see whether the washer completes a cycle without heating. 3. If E67 appears again, stop using the washer. 4. Call us and mention which wash temperature you were using.

! Why to stop there

The code names the sensing relay, so we test the heater circuit and the board relay and do not guess which one is the cause.
We check the heater and ground path before we suggest a board.
Before any work you get a written price, and the finished repair has a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" E98 / E9FElectrolux Washer Codes E98 and E9F: Console Control and Communication EA1Electrolux Washer Code EA1: Power Frequency Outside Its Limits EA2 / EA3Electrolux Washer EA2 and EA3: Supply Voltage Too High or Too Low EA5 / EAEElectrolux Washer Codes EA5 and EAE: Voltage and Line Relay Sensing EF1Electrolux Washer Code EF1: Clogged Drain Pump EF2Electrolux Washer Code EF2: Too Much Detergent

E67E67 questions

Does every Electrolux washer show E67?

No. It applies to models with an internal water heater. If your washer has no heater, E67 should not be the code you are seeing, and we would look at the display more carefully.

Can I wash with cold water until it is fixed?

It may work on some cycles, but the code can still stop the washer, even on a cold wash. Do not keep forcing it if it stops, and call us for a proper test.

Is the heater itself always bad?

Not always. The code is about the relay sensing, so the wiring and the board are tested along with the heater. We tell you which part is behind it before you approve any work.

Book a visit

Still seeing E67?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150