Error code · Washer

Electrolux Washer Error E13 (Tub Leak or Air Bell Leak)

Medium · inspection needed

Code: E13
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E13 means

E13 tells you an Electrolux Wave-Touch or IQ-Touch front-load washer in the EWFLW65H or EIFLW55H series, such as the EWFLW65HIW or EIFLW55HMB, believes it has a water leak in the tub or an air leak in the air bell. The air bell is the small chamber the pressure sensor reads through. The chart behind this entry covers the 2008 to 2010 washers, and later front-loaders may follow it too, though we cannot promise that.

Common causes of E13

Water escaping from the tub or a seal
Air escaping from the air bell or its tube
The pressure sensor reading through that tube
The main control board

✓ One safe check you can try

1. Look on the floor and around the washer for water. If you find some, stop the washer. 2. Make sure the fill and drain hoses are snug at both ends. 3. Wipe the door boot dry and see if it is torn or has trapped debris. 4. If E13 returns, unplug the washer and call us.

! Why to stop there

Water and air leaks need different tests, so we check both before touching the sensor.
The pressure sensor is tested only after the tube and bell are ruled out.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" E93 / E97Electrolux Washer E93 / E97: Console or Main Board Control Problem E94Electrolux Washer Code E94: Main Board Control Problem E95Electrolux Washer E95: Memory Chip Communication E98 / E9FElectrolux Washer Codes E98 and E9F: Console Control and Communication EA1Electrolux Washer Code EA1: Power Frequency Outside Its Limits EA2 / EA3Electrolux Washer EA2 and EA3: Supply Voltage Too High or Too Low

E13E13 questions

Does E13 always mean water on the floor?

No. It can also be an air leak in the air bell that disturbs the reading, so look for water but do not be surprised if you find none.

Is it safe to run another load with E13?

If you see water, no. Keep the washer off and dry the area until it is checked. If there is no water, it is still better to wait for a proper test.

What is an air bell?

It is a small chamber that connects tub pressure to the pressure sensor, so the washer can read the water level. A leak in it can give a false reading.

Book a visit

Still seeing E13?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150