Error code · Washer

Electrolux Washer Code E94: Main Board Control Problem

Medium · inspection needed

Code: E94
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E94 means

On Electrolux front-load washers of the Wave-Touch and IQ-Touch design like the EWFLW65HIW and EIFLW55HIW, E94 means the main control board has found a control problem of its own. The main board is the brain that runs fill, wash, drain and spin. The display shows E94 and the washer may stop or not start. We still look after these older washers in Houston and will tell you if the repair costs more than it should.

Common causes of E94

The main control board
Its power and ground connections
The harness to the console and motor control

✓ One safe check you can try

1. Switch the washer off and unplug it for a few minutes. 2. Plug it directly into the wall outlet, not an extension cord. 3. Run one short cycle and watch the display. 4. If E94 comes back, stop using the washer and give us a call.

! Why to stop there

Connectors and incoming power are checked before the main board is blamed.
If the board is the cause, we explain whether replacing it suits an older washer.
Our quote comes in writing, and the work is covered by a 30-day workmanship warranty once you approve it.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" E93 / E97Electrolux Washer E93 / E97: Console or Main Board Control Problem E95Electrolux Washer E95: Memory Chip Communication E98 / E9FElectrolux Washer Codes E98 and E9F: Console Control and Communication EA1Electrolux Washer Code EA1: Power Frequency Outside Its Limits EA2 / EA3Electrolux Washer EA2 and EA3: Supply Voltage Too High or Too Low EA5 / EAEElectrolux Washer Codes EA5 and EAE: Voltage and Line Relay Sensing

E94E94 questions

Must the board always be replaced for E94?

No. Loose connectors and supply problems can look like a board problem, so those get tested first. If the board is the cause, we give you the cost and whether it is worth it.

May I keep running the washer?

If it works after a restart you might finish a load, but the code can return and stop it with wet clothes inside. We would not rely on it until it has been checked.

How does E94 differ from E93?

They are related. E94 points to the main board only, while E93 refers to the console or the main board, and we test the board and its connections for both.

Book a visit

Still seeing E94?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150