EFMC617STT
Electrolux Perfect Steam EFMC617STT Electric Dryer Repair
Most common issues on this model
- Steam refresh that does not start
- Dryer with weak or no heat
- Cycle that stops early
- Noisy drum or belt
The EFMC617STT is a front load Perfect Steam electric dryer with an 8.0 cubic foot drum, Instant Refresh and 8 cycles. STT is the finish code, and a revision called EFMC617STT0 is on record. Electrolux no longer sells it, so you are most likely looking at an older unit that has dried many loads.
A steam-equipped dryer has two systems to check. On the drying side, we look at the vent, lint, element and safety parts. On the steam side, we look at the water supply, the hose and the inlet. If the cycle stops early, we also test the sensors and the controls, and noise takes us to the belt and the rollers.
The number from your label goes on our order before we buy a part. You are told the price first. If a repair would not make sense for the age of the dryer, we tell you honestly. A completed repair is covered for 30 days.
Key features
- Front load Perfect Steam electric dryer, 8.0 cu. ft.
- Instant Refresh with 8 cycles
- Finish code STT
- Revision EFMC617STT0 is on record
Error codes this model can show
Why will the steam refresh on my dryer not start?
On the EFMC617STT the feature needs water as well as power. We check the supply, the hose and the inlet valve first, and only then look at the controls.
Why does my dryer stop before the cycle is done?
Overheating from poor airflow, a sensor problem or a worn belt can all stop a cycle. We check airflow first because it is the simplest.
Does the STT ending matter?
STT is the finish code of this model. It guides trim and door parts, and the revision may matter too, so we match your label to whatever we order.
Book repair for your EFMC617STT
Book online in about a minute, or give us a call. Same-day appointments are available inside the Loop on most days, and next-day service across the rest of Houston.