Error code · Washer

Electrolux Washer E00: No Error Stored

Low risk · DIY check OK

Code: E00
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E00 means

E00 on Electrolux Wave-Touch and IQ-Touch front-load washers in the EWFLW65H and EIFLW55H series, such as the EWFLW65HIW and EIFLW55HMB, is not a problem. It appears when the washer is reading back its stored codes, and E00 means no failure code has been recorded. The chart comes from the 2008 to 2010 generation, and a later model may use it the same way, but we cannot say so for sure. If your washer has a real problem, you will see a different code.

Common causes of E00

Nothing is wrong. E00 reports that no error is stored
A recent reset that cleared earlier codes

✓ One safe check you can try

1. Do not repair anything because of E00 alone. 2. If the washer is acting up, note exactly what it does and any other code. 3. Run a normal cycle and watch it. 4. If the problem continues, call us and tell us what you saw.

! Why to stop there

If something is wrong but E00 shows, the washer simply has no stored code, and we test how it behaves through a cycle.
We check water, drain and door behavior directly.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" E93 / E97Electrolux Washer E93 / E97: Console or Main Board Control Problem E94Electrolux Washer Code E94: Main Board Control Problem E95Electrolux Washer E95: Memory Chip Communication E98 / E9FElectrolux Washer Codes E98 and E9F: Console Control and Communication EA1Electrolux Washer Code EA1: Power Frequency Outside Its Limits EA2 / EA3Electrolux Washer EA2 and EA3: Supply Voltage Too High or Too Low

E00E00 questions

Is E00 an error on my washer?

No. It tells you the washer has no failure code recorded. It appears when the stored codes are read back, and E00 simply means the list is empty.

My washer has a problem but shows E00. Why?

Not every problem stores a code. If the washer is acting up, we check water, drain, door and motor behavior in person instead of relying on the code list.

Should I replace anything because of E00?

No. E00 alone is a normal reading and no part needs to be replaced. Note what the washer does and call us if the problem continues.

Book a visit

Still unsure about E00?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150