Error code · Washer

Pressure Sensor Calibration Problem, Electrolux Washer E32

Medium · inspection needed

Code: E32
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E32 means

E32 on Electrolux Wave-Touch and IQ-Touch front-load washers in the EWFLW65H and EIFLW55H series, such as the EWFLW65HSS and EIFLW55HIW, is listed as a pressure sensor calibration problem. The control and the pressure sensor are not agreeing on the water level reading. The chart calls for the same wiring and sensor checks as E31. The chart is for the 2008 to 2010 generation, so later front-loaders may differ.

Common causes of E32

The pressure sensor reading
Wiring between the sensor and the main board
The main control board

✓ One safe check you can try

1. Make sure the washer is empty and the drum has no water in it. 2. Unplug the washer for a short time, then plug it back in. 3. Run a short cycle and see whether E32 returns. 4. If E32 stays, stop the washer and call us.

! Why to stop there

The code names a calibration problem, not a failed part, so we test the sensor and its wiring first.
We check the main control last.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" EA2 / EA3Electrolux Washer EA2 and EA3: Supply Voltage Too High or Too Low EA5 / EAEElectrolux Washer Codes EA5 and EAE: Voltage and Line Relay Sensing EF1Electrolux Washer Code EF1: Clogged Drain Pump EF2Electrolux Washer Code EF2: Too Much Detergent EF5Electrolux Washer EF5: Hot and Cold Water Mix-Up EF8Electrolux Washer Code EF8: Stuck Key

E32E32 questions

What does calibration mean in E32?

The control and the pressure sensor are not agreeing on the water level reading. The chart lists it as a calibration problem and uses the same checks as E31.

Is E32 the same as E31?

They are related and use the same wiring and sensor checks. E31 is a switch failure message and E32 is about the calibration of the reading.

Can I still wash with E32 showing?

We would wait until it is checked, because the washer may not judge the water level correctly and could underfill or overfill on the next load.

Book a visit

Still seeing E32?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150