Error code · Washer

Electrolux Washer Code E5F: Motor Control Keeps Resetting

Medium · inspection needed

Code: E5F
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E5F means

E5F is shown by Electrolux Wave-Touch and IQ-Touch front-load machines, such as the EWFLW65HIW and EIFLW55HIW, when the motor control board is restarting itself over and over. The board cannot hold steady long enough to run the drum. You will see E5F and the washer may start, stall and start again. Many Houston laundry rooms still have one of these older washers, and we will repair it or tell you plainly that it is time to replace it.

Common causes of E5F

The motor control board
Wiring or connectors that cut in and out
The power supply reaching the washer

✓ One safe check you can try

1. Switch the washer off and plug it straight into the wall outlet. 2. Make sure the plug sits firmly and the cord is not cracked or crushed behind the washer. 3. Power it on and run one short cycle. 4. If E5F shows again, leave the washer off and call us.

! Why to stop there

Unsteady input power can make a healthy board restart, so we check the outlet and cord as well as the board.
Connectors are inspected for looseness or heat marks.
The quoted price is given to you in writing beforehand, and the finished work comes with a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" EF5Electrolux Washer EF5: Hot and Cold Water Mix-Up EF8Electrolux Washer Code EF8: Stuck Key HO SEElectrolux Washer Message HO SE: Hoses on the Wrong Inlets LOCElectrolux Washer Message LOC: Control Lock Is On NO WATERElectrolux Washer Message NO WATER: Install Cycle Cannot Fill E93 / E97Electrolux Washer E93 / E97: Console or Main Board Control Problem

E5FE5F questions

What does a resetting board look like?

The motor control keeps restarting instead of running steadily. The washer may hesitate, stall or begin again in the middle of a cycle, and E5F appears on the display.

Could my outlet be behind E5F?

Poor power can contribute, so we look at the outlet, the cord and the wiring before blaming the board. A shaky supply can make a good board restart.

Should I keep running cycles?

One try is enough. More restarts only strain the board and do not solve the cause, so it is better to leave the washer off and call us.

Book a visit

Still seeing E5F?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150