Error code · Washer

Electrolux Washer E71: Drum Water Temperature Sensor

Medium · inspection needed

Code: E71
Appliance: Washer
Brand: Electrolux
Warranty: 30-day workmanship

What E71 means

E71 points to the drum water temperature sensor, an NTC thermistor tied to the tub heater, on Electrolux front-loaders in the Wave-Touch and IQ-Touch line such as the EWFLW65HSS and EIFLW55HIW. The control is not getting a believable temperature reading from the water in the drum. The display shows E71 and the washer may stop before or during a heated wash. These older washers remain in many Houston homes, and we are plain with you when a repair is not a good value.

Common causes of E71

The water temperature sensor in the tub
The wiring and plug for that sensor
The tub heating element
The motor control board that reads the sensor

✓ One safe check you can try

1. Turn the washer off and open the door when it unlocks. 2. Check for standing water in the drum. 3. Try a small cold wash. 4. If E71 comes up again, skip heated cycles and give us a call.

! Why to stop there

The bad reading could start at the sensor, its wiring or the heater, so each one is tested before a part is replaced.
We compare the sensor against what the water is really doing.
You approve a written price first, and the finished job is guaranteed for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SU dSElectrolux Washer Message SU dS: Too Many Suds Detected TOO MUCH DETERGENTElectrolux Washer Message "TOO MUCH DETERGENT" LOCElectrolux Washer Message LOC: Control Lock Is On NO WATERElectrolux Washer Message NO WATER: Install Cycle Cannot Fill E93 / E97Electrolux Washer E93 / E97: Console or Main Board Control Problem E94Electrolux Washer Code E94: Main Board Control Problem E95Electrolux Washer E95: Memory Chip Communication E98 / E9FElectrolux Washer Codes E98 and E9F: Console Control and Communication

E71E71 questions

What is an NTC sensor?

It is a small temperature sensor whose electrical resistance changes with heat. The washer reads it to know how warm the drum water is, and E71 means that reading is missing or not believable.

Will cold washes still work?

Sometimes, but the code can stop any cycle that needs the sensor. Do not keep forcing the washer if it stops, since repeated tries tell us nothing new.

Does E71 mean the heater is bad?

Not always. The sensor and its wiring come up first, then the heater, then the board. We test in that order so the quote covers only the part truly causing the code.

Book a visit

Still seeing E71?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 979-9150